Unlay the two ends to be joined-at least one turn for each round of tucks to be made.If desired, for neatness, the splice can be tapered by adding additional rounds of tucks, first with halved strands and then by halving again before the final round.įor joining two ropes of the same size together.Never use less than three rounds of tucks if the eye is to bear any strain. For the second round, take each end over one strand and under the next towards the left.Pull each end tight enough to make a tidy and snug fit.If two ends come from under the same strand, the splice is wrong. There should now be one end coming out from under each strand on the standing part.Turn the whole splice over, then take the third end (C) and lead it over to the right of the third strand, so that the third tuck can, again, be made from right to left, as in step 3.Pick up the left end (B) and tuck it - again from right to left - under the next strand to the left of the one under which (A) is tucked.Take the middle end (A) and tuck it, from right to left, underneath the nearest strand of the standing part.Unlay the three strands at the end of the rope, enough to make at least three tucks - about one turn for each tuck - and form an eye by laying the opened strands on top of the standing part of the rope.Which while desirable for some applications I would imagine a poor use for halyards. If you do find yourself acquiring old nylon line, be sure to determine whether it is Static or Dynamic. After going back and watching this a few times I'm having great success! I purchased some Splicing Fids on Amazon and while the Fid sizes vary from those seen in the video, I've been able to use Andy Wall's information to figure out the measurements needed. It's been great to follow along with the video and much easier then other diagrams and books that I've used in the past. Giving my new found line a new purpose required some rewarding splicing. Here I had my first real life experience of the old english idiom “money for old rope”. After a rope is used for a couple heavy falls it is deemed unsafe for humans to climb on, but still very capable of securing your boat! They were happy to contribute some rope to become line and this motivated me to find a great video on: How to Eye Splice Double Braid Nylon Rope I added making these lines to the to-do list and after some shopping around I discovered that I was looking at a couple hundred bucks to get the materials for what I needed.Īt this point in the season I'm over budget and tying up the last odds and ends always proves to surprisingly expensive! Not to suggest that lines are something to skimp on, but without room in the budget I went down to a local indoor rock climbing gym and asked if they had any old rope they were willing to part with. Luckily in this situation the boat yard was well equipped to assist, but not without a few pokes and prods at my boating ego regarding my slacked preparedness. Immediately after launching my boat this season, it became clear during the move from the Travelift to the dock that I had over looked preparing some simple, yet much needed dock lines. Email This Page to a FriendPreview: How to Eye Splice Double Braid Nylon Rope
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |